Previous  

---

6 Operating procedures

6.1 Preparing to boot from CD

Please make sure that your CDROM is the first bootable device in your BIOS setting. If your computer can`t boot from the cdrom, plase take a look at "HOWTO set BIOS to boot from CD".

6.2 Using The EasyClone

1. Message box

The initial message is  ;

If you select a partition as source, the message will change to :



If you select a disk as source, the message will change to:



If you select a partition as source, the message will change to :



If you select a disk as source, the message will change to:



 

2. Source/Destination device selection box




Field	Values
Bootable	YES: The partition is active(most probably there is a operating system on it .) NO : The partition is not active.
Type	Only available for disk. Fixed: This is a fixed disk(inside the computer) Removable: USB storage device, IEEE 1394 device and so on.
Device	HardDisk or Partition
Description	If Device is HardDisk : the Serial No of the harddisk. If Device is Partition : the file system type of the partition FAT/NTFS.
Start	Only available for partition. The start sector address of the parition.
Size	The size of the parition/harddisk.
























3. Activate button



if this button is selected, the destination partition will set to be active. Click this if you want to transfer a previous Windows installation to the destination partition.



4. Progress bar

The progress of the clone process.



5. Time consumption boxes



Start time: the start time of the clone process.

Current Time: current time.



6. “Start clone“ button

only partition -> partition and disk->disk operation is supported.

 

---

Previous